Precautions for the operation of CNC bus processing machine

by:JPSK     2021-06-06
The CNC bus processing machine is suitable for processing periodic and compound production parts. The market demand for some products is cyclical and seasonal. If a special production line is used, the gain is more than the loss. The processing efficiency with ordinary equipment is too low, the quality is unstable, and the quantity is difficult to guarantee. After the first trial cut using the machining center, the program and related production information can be retained, and the next time the product is reproduced, the production can be started with a very short preparation time. Today we explain the operation precautions of the CNC bus processing machine: Before the operation of the CNC bus processing machine: 1. The fuel tank must be filled with oil before starting for the first time to avoid damage to the oil pump. 2. You must read this manual carefully and be familiar with the structure, performance and operation methods of the machine. 3. Don't bring scarves or coats and other clothes to operate. 4. Use the correct method to work in order to stop and get rid of danger as soon as possible in the event of a failure. 5. If the ambient temperature is lower than 0℃, it should be turned on and run for a few minutes before working. During the operation of the CNC bus processing machine: 1. The bus processing machine installation, debugging (mold adjustment, blade gap adjustment) or disassembly of the mold must be carried out by personnel familiar with the machine in accordance with the prescribed regulations. 2. When the machine is working normally, do not put your hands or part of your body between the upper and lower molds (blade) to avoid accidents. 3. Do not put all sundries and tools on the workbench to avoid accidents caused by rolling into the mold or knife edge. 4. Since the machine can be operated by multiple people, there must be someone responsible for directing production. 5. Be sure to choose the gap between the shear blade and the die and the bending radius according to the thickness of the copper bar (or aluminum bar). 6. Be sure to stop the machine when changing the mold to avoid danger. 7. During operation, be careful when holding the workpiece and waiting for the slide to go down. 8. The sharpness of the cutting edge of the blade and die should be checked regularly. If the cutting edge is found to be dull, it should be sharpened or replaced in time. 9. Keep the oil clean and the oil path unblocked, and lubricate the moving parts of each unit every shift. 10. The electrical and hydraulic components must be flexible in action and in the correct position. If abnormalities are found, they must be stopped immediately for inspection. After the CNC bus processing machine is operated: After the operation, it must be shut down safely in the following order: (1) Turn off the working buttons of each unit. (2) Turn off the power switch on the operation panel. (3) Turn off the main circuit air switch. (4) The reasons why the installation of the power switch bus in the shutdown workshop does not meet the requirements: (1) The cable construction units did not coordinate well, and only the cables laid by themselves can pass. (2) Failure to coordinate well with the civil engineering unit when plugging the strong electric shaft, and the construction personnel did not master the plugging technology. (3) The material is not up to standard, and the purchaser does not purchase the cable fixing bracket and the terminal (wire lug) according to the standard. (4) The area of u200bu200bthe construction major for the electrical major to make strong electric shafts is too small, which makes it difficult to arrange the strong electric shafts.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...