Lubrication of bus bar processing machine

by:JPSK     2021-06-01
The bus bar processing machine has five processing units: shearing, punching, large bending, and small bending. The main function is to process copper and aluminum bus bars of different specifications. You can easily and quickly treat copper with the corresponding processing unit. , Aluminum bar is cut, punched (round hole, waist-shaped hole), flat bending, vertical bending, embossing, flattening, twisting, pressing cable joints and other different processing. Lubrication is an important work to reduce the failure of the bus processing machine, and the bus processing machine can be used better if lubrication is done. Let's take a look at the lubrication work of the bus processing machine? 1. Shear and apply lubricating oil to each moving part of the busbar processing machine once in the morning and the afternoon before the shift. Use the observation holes of the upper and lower knife blocks to observe the actual cutting position. Use the scale slider to block the material, and place the bus bar on the workbench. Determine the cutting size, and then use the pressing hand wheel to press the bus bar to prevent the material from lifting and damaging the mold. 2. Apply lubricating oil to each moving part of the busbar processing machine once in the morning and in the afternoon before punching and shift. In the punching process, ensure that the processing data adhere to the level. It is necessary to select matching molds. When punching, remember not to mix up and down molds with different inner diameters. When processing long-term holes, the direction of the upper and lower molds must be the same, otherwise the mold will be damaged. Lubrication not only reduces the failure of the busbar processing machine, but also prolongs the service life, which is an essential maintenance content.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...