How to clean the bus processing machine

by:JPSK     2021-06-04
Any machine used for a long time will generate a lot of dust and product debris. If it is not cleaned in time, it may cause the normal operation of the machine. Therefore, for the bus processing machine, in addition to maintenance work, cleaning work is also the key .  1. Hot oil cleaning method. Because of the long-term use, the bearing hardened by soft dry oil or anti-rust paste should be immersed in hot engine oil at 100-200℃, clamp the bearing with pliers, and clean the oil on the bearing with a brush. The soft dry oil or anti-rust paste is heated to 100-200°C and melted, and it is easily washed out from the gap of the bearing. Sometimes it is only necessary to shake the bearing repeatedly in the oil. The oil will also flow away from the cracks. When cleaning the centripetal spherical bearing of the old busbar processing machine motor or the imported motor, the ball, the bead frame, and the inner ring should be rotated laterally from the outer ring and then immersed in hot oil. The short cylindrical roller bearing is also cleaned. The rollers, bead holder, inner ring and outer ring should be separated. When hot oil is cleaned, the temperature of the oil should not exceed 20°C. If you use an open flame to heat directly, you should pay attention to avoid burning the oil. The bearing should be hung in the oil pan. The sinking of the bottom will cause overheating and reduce the hardness.   2. General cleaning method Put the bearing in kerosene for 5-10 minutes, hold the inner ring with one hand, and change the outer ring with the other. The dry oil or anti-rust paste on the bearing will fall off. Then put the bearing of the busbar processing machine into cleaner kerosene, rinse it with a delicate and soft brush, wash the balls and the oil in the gap, put it in gasoline and clean it once, take it out and place it on clean paper . When cleaning radial spherical ball bearings and short cylindrical roller bearings, the balls, the ball frame, the inner ring and the outer ring should be separated and cleaned. The bearings installed on the busbar processing machine shafts are cleaned mainly by spraying oil or spraying with oil guns. For simple cleaning of oil, use kerosene and then gasoline; for oil that is difficult to clean, use 100-200℃ first. Rinse with hot engine oil or spray from an oil gun, then clean it with gasoline. Must pay attention not to scratch the bearing with sharp objects: hard grease or rust, to avoid damaging the finish of the rolling body and groove ring of the bearing, wipe the cleaned bearing with a clean cloth.   So I remind everyone that when you use the bus processing machine in the future, you must always do his cleaning work.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...